- This hinge is made for gates with a curved or arched top.
- Made for gates where the surface of the gate is flush with the post.
- This is a pintle style hinge. Gate straps fit over vertical pintles that are installed on the gate post.
- This hinge is sold by the set. A set includes a top hinge and a bottom hinge (as shown in the image). A set is what is needed to hang one gate.
- Important:These hinges are handed (left hand or right hand).
- Using the dropdown above will change the image to reflect the handing.
- Top hinge is approximately 11.5" wide by 8.5" tall.
- Bottom hinge is approximately 5-3/8" tall by 7-3/4" wide.
- Each pintle plate is approximately 5-3/8" tall by 1.5" wide, plate projection is 1-7/16"
|Weight Rating||Not Rated|
|Strap Length||Upper Strap: 11 - 1/2", Lower: 7 - 3/4"|
|Pad Length||5 - 3/8"|
|Pad Width||1 - 1/2"|
|Mounting Hardware Included||Yes|
|California Residents||Prop 65 Warning|
You're reviewing Pintle Hinge for Arched Top Gates
No Reviews Yet
No Questions Asked Yet. Use the form below to ask one.