My Cart: 0 item(s)
Overview
- This chest lid hinge is made from .080 guage steel
- Made to use on 3/4" thick material.
- Flat leaf measures 1-1/2" tall by 2"
- Bent leaf measures 1-1/2" tall by 3/4" from hinge pin to bend and 1-1/2" tall by 1-1/4" after bend.
Material | Steel |
Mounting Hardware Included | Yes |
Mounting Hardware Type | Flat head wood screws |
California Residents | Prop 65 Warning |
You're reviewing
Steel Lid Hinge
No Reviews Yet
1 Question asked about Steel Lid Hinge
Q
Jerry Grace • 12/17/2017, 6:18:26 PM
As you look at the hinge in the picture, does the longer side on the left close up to the other side of the hinge on the right? The hinge I am looking to replace is a drop-down door, with the hinges on the bottom of the cabinet. The hinge 'flap' on the left of your picture would would be screwed into the door that is under that part of the hinge, and need to close tight to the other part of the hinge on the bottom of the cabinet. Hope this is clear enough. It looks like it could be what I am looking for. Thanks so much.
Jerry
A
12/18/2017, 4:12:52 PM
Hi Jerry! If you look under the "More Information" section of this page, there is a link to an installation diagram that should clarify the installation for you.
Estimate Shipping