My Cart: 0 item(s)
| Material | Steel |
| Width | 3 - 1/8" |
| Height | 1 - 3/16" |
| Material Thickness | 1/16" |
| Mounting Hardware Included | No |
| Mounting Hardware Type | #8 Flat Head Screws |
| California Residents | Prop 65 Warning |
You're reviewing
Sewing Machine Hinge
No Reviews Yet
4 Questions asked about Sewing Machine Hinge
Q
danny lane • 01/28/2018, 6:27:06 AM
What is the size of the hinge?
A
01/30/2018, 12:05:53 PM
This hinge measures 1-3/16" high (the length of the pin) and 3-1/8" wide when the hinge is in the open position. The leaves are 1/16" thick.
Q
Russell Klabouch • 03/18/2018, 10:19:21 AM
Will this hinge close past 90°? I am repairing a drop front desk. The front cants back about 10° from vertical.
A
03/19/2018, 3:20:30 PM
Hi Russell! Correct, this hinge can fold back onto itself if there is nothing to obstruct it so both leaves lie on top of one another. It should be able to slightly close past 90 degrees for you.
Q
Lisa • 09/01/2018, 3:34:46 PM
I have a drop down desk. Looking to replace the hinges that have broken. Its an oval hinge that is approximately 4x1/2 inches long.. will this hinge work?
A
09/04/2018, 11:09:24 AM
Hi Lisa! This hinge won't match the length so as long as you don't mind redoing screw holes. It would be recommended to send in a couple of photos of the broken hardware you're trying to replace to our email address i[email protected] and someone can assist you with a replacement.
Q
George • 01/23/2019, 8:27:23 AM
Does hinge have a stop at 180' ?
A
01/23/2019, 9:58:48 AM
It does, this hinge will not swing further than 180 degrees.
Estimate Shipping
