My Cart: 0 item(s)

 

Secure Checkout
One Piece Face Frame Hinge, Minimal Gap - Discontinued
    One Piece Face Frame Hinge, Minimal Gap - Discontinued
    Purchase One Piece Face Frame Hinge, Minimal Gap - Discontinued
    SKU #: 701190 Not Rated Yet

    One Piece Face Frame Hinge, Minimal Gap - Discontinued

    $0.00 Each
      HardwareSource - Checkmark Discontinued

      Overview

      Please Note: This hinge has been discontinued by the manufacturer. We have left this product page up for reference only. This was a very unique hinge (due to many different factors) that has no exact replacement options. The unique factors were as follows:

      • 48mm Screwhole center to center
      • 1-1/8" Overlay
      • 135 Degree opening angle
      • One piece compact design

      The closest replacement option we carry would be a Grass 170 Degree hinge for face frame cabinets. This is our SKU# B10152 which can be found by clicking here or under related products below. This hinge provides a large opening angle (170 degrees) while also having a 48 mm screwhole center to center. It only provides a 3/4" overlay, however, and would require you to notch out your cabinet frame (as seen here) to acheive a 1-1/8" overlay. The Grass hinge is also a much larger two piece setup as opposed to the small one piece design that this hinge provided.

      • One piece compact European hinge
      • For face frame cabinets with overlay doors
      • Accomodates overlays from 26 mm to 29 mm (1-1/32" to 1-1/8")
      • Shallow cup depth of 10 mm
      • Made for door thicknesses from 5/8" to 3/4".
      • Made for face frame thickness of 3/4".
      • This hinge requires a 6 mm (1/4") bore distance. The bore distance is the distance from the edge of the door to the edge of the 35mm cup drilled in the back of the door.
      Nickel
      Steel
      Yes
      One-Piece
      135 Degrees
      35
      48mm (1-7/8")
      No
      Two #6 Flat Head Screws (Hinge Cup), Two #8 Flat Head Screws (Mounting Plate)
      Prop 65 Warning
      You're reviewing One Piece Face Frame Hinge, Minimal Gap - Discontinued
      Rate Product
      No Reviews Yet

      2 Questions asked about One Piece Face Frame Hinge, Minimal Gap - Discontinued

      Q rick • 02/19/2018, 1:25:19 PM The specs for this hinge look like a match for what we need, except that my bore distance is only 1/8". Would that work anyway? Thanks!
      A 02/19/2018, 3:11:09 PM Hi Rick. The minimum recommended bore distance should be 1/4�. Having a bore distance smaller than that may impact the overlay dimension and possibly make the door bind/clip against the frame.
      Q Derek Heyn • 03/06/2018, 7:49:15 AM Hello i am trying ro replace Mepla 511.243.01.92. Will these work? Thank you.
      A 03/06/2018, 9:26:41 AM We don't have reference to that old Mepla part number, but if your hinge is identical to ours, it's likely the one for you, as its a very unique hinge, that's very specific, and does not have another that looks like it. If you are stil unsure, email us a photo of it to [email protected], and one of our technicians can take a look and confirm for you within 24 hours!
      Estimate Shipping