• Bar latch for cabinets and shutters.
• Made from Type 304 stainless steel.
• Bar latch measures 3" wide by 2-1/2" tall. Projection is 7/8".
• Made from 0.112" thick material.
• Bar latch features a thumbscrew which can be turned to lock down the latch.
• Stainless steel pan head sheet metal screws are included.

Finishes:

• Polished Stainless Steel

• Smooth black stainless steel strap with pintle
• Strap measures 1" by 4-1/4" with either a 2-3/16" offset or a 1-1/4" offset.
• Pintle is 4-1/2" long by 7/16" diameter thread.
• Matching black stainless steel wood screws are included
• Loose joint hinges permit easy hanging and removal of shutters
• For use where shutters cover windows that are recessed into brick or stone you would normally use the 2-3/16" offset model.
• For use where shutters cover windows that are recessed into a wood frame you would normally use the 1-1/4"" offset model.
• Offset of hinge allows shutter to open 180 degrees
• Made from stainless steel base material
• This product is sold by the set. A set is 4 hinges, enough to do 2 shutters.
• If you need a lag anchor for this product for a masonary installation, order our SKU 244130. It is a 1/2" diameter lag anchor (in the long version) but it will work for the 7/16" diameter thread on the pintle.It is offered for purchase during checkout.

Finishes:

• Smooth black finish

• This surface mounted shutter hinge is used where the blind or shutter is flush with the casing. For use in frame or masonry construction.
• Smooth stainless steel strap with pintle
• Loose joint hinges permit easy hanging and removal of shutters
• Made from stainless steel base material
• This product is sold by the set. A set is 4 hinges, enough to do 2 shutters.
• Matching black stainless steel screws are included
• A pair of these shutter hinges is designed to hang a shutter of up to 20lbs. For shutters taller than 60" a third center hinge may be required.
• For masonry installation use lag type anchors.

Finishes:

• Smooth black finish

• Stainless steel shutter hinge for interior shutters.
• Made to fit shutter panel thickness of 1-1/8" to 1-3/16".
• Hinge pin is removable.
• Hinge measures 2-1/2" tall by 2-1/2" wide as measured in the open position and not including the bend in the larger leaf.
• The bend in the larger leaf measures 15/16".
• Made from solid stainless steel and is suitable for installation in damp or corrosive environments.
• Uses #6 flat head screws (not included). Use up to 7 screws per hinge.
• When you checkout you will be offered for purchase screws with a matching finish.

Finishes:

• Industrial Stainless Steel