• Stainless steel spring butt hinges.
• Spring tension is adjustable.
• Screw hole patterns conform to ANSI specifications for template hinges.
• Pivot point aligns with non-spring hinges of the same size.
• Screws are included.
• Photo to left shows hinge with the Bronze finish.
• PLEASE NOTE: Some of the models have a stainless steel spring and some of the models have a steel spring. The steel spring is coated with laquer which will offer protection but will eventually rust.

Maximum door weight using three spring hinges

• 4" - 110 lbs.
• 4-1/2" - 150 lbs.

Finishes:

• Satin Stainless Steel

• Hinge is made from stamped stainless steel
• Stainless steel is Type 304
• Polished finish
• Uses 6 each #10 flat head screws (not included). Flat head stainless steel screws are offered for purchase during checkout.

Finishes:

• Polished

• Stainless steel T hinge, recommended for vinyl, redwood, cedar and ACQ (treated) lumber.
• Excellent for use anywhere that corrosion is a problem.
• Heavy duty construction, non-removeable hinge pin.
• Strap length is measured from the tip of the strap to the far end of the hinge pin barrel.
• Pad width is measured from the edge of the pad to the inside edge of the hinge pin barrel.
• Strap width means the widest part of the strap.
• Hinge is made from Type 316 Stainless. Fasteners are made from Type 305 Stainless.
• Stainless steel screws are included.
• This hinge is sold by the "Pair". A pair is 2 hinges, usually what is required to hang one door.

Finishes:

• Satin Stainless Steel

• Excellent for use anywhere corrosion is a problem or the look of stainless steel is desired.
• Stainless steel is recommended for vinyl, redwood, cedar and ACQ (treated) lumber.
• Made from solid stainless steel (Type 304)
• Stainless steel screws are included.
• PLEASE NOTE: The "Size" refers to the length of one hinge leaf. The "Size Open" dimension is the tip-to-tip measurement when the hinge is in the open position as shown in the photo.

Finishes:

• Satin Stainless Steel

• Stainless steel is recommended for vinyl, redwood, cedar and ACQ (treated) lumber.
• Excellent for use anywhere corrosion is a problem or the look of stainless steel is desired.
• Heavy duty construction.
• Made from solid stainless steel (Type 304)
• Strap length is measured from the tip of the strap to the far end of the hinge pin barrel.
• Pad width is measured from the edge of the pad to the inside edge of the hinge pin barrel.
• Strap width means widest part of strap.
• Stainless steel screws are included.

Finishes:

• Satin Stainless Steel

• Stainless steel hinge for use near marine environments or anywhere the look of stainless steel is desired.
• Stainless steel is recommended for vinyl, redwood, cedar and ACQ (treated) lumber.
• Hinge measures approximately 4.25" tall by 5" wide.
• Short leaf is 1-9/16" wide. Long leaf is 3-3/8" wide.
• Stainless steel fasteners are included.

Finishes:

• Satin Stainless Steel